Can't discover Omada Gigabit VPN Router (ER605) with Omada Hardware Controller
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Can't discover Omada Gigabit VPN Router (ER605) with Omada Hardware Controller
Hello,
I have an Omada network set up, with an OC200 hardware controller, and four APs (one of which is an outdoor AP). I recently replaced my router with the ER605 Omada Gigabit VPN router, have set it up, and am trying to get the OC200 to adopt it. However, the controller only shows the 4 APs connected to it, it doesn't show the router and nothing is listed as pending. I have checked and the router is using the 192.168.0.1 IP address, and all the local IPs are on the 192.168.0.0/24 subnet, and I can access the controller and the router just fine from any machine on the local network through their IP addresses. Does anyone have any advice?