Connect branch office using Omada Hardware controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Connect branch office using Omada Hardware controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Connect branch office using Omada Hardware controller
Connect branch office using Omada Hardware controller
2021-10-07 20:55:13
Model: OC200  
Hardware Version: V1
Firmware Version: 4.4.4

Both my company headquarters and branch office are connected to the internet via an ER 605 gateway.

OC 200 hardware controller is installed in headquarters, with cloud access, of course.

How can I establish a connection ?

The only solution is the following ?

 

https://www.tp-link.com/gr/support/faq/2163/

 

Or I can use hardware controller ?

On the controller interface, I can see all headquarters' EAPs and the ER 605. Is there a way to add EAPs and ER-605 of the branch office ?

 

Internet connection for both headquarters and branch is through dynamic IP...

 

Thanks a lot in advance.

 

D. K.

 

 

 

  0      
  0      
#1
Options
1 Reply
Re:Connect branch office using Omada Hardware controller
2021-10-09 11:11:27

Dear @dakorres,

 

dakorres wrote

On the controller interface, I can see all headquarters' EAPs and the ER 605. Is there a way to add EAPs and ER-605 of the branch office ?

 

Please refer to the guide below:

How to manage Omada devices at different sites across Internet using Omada Controller

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options