TL-605 firewall and virtual server?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-605 firewall and virtual server?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Grohk

2021-03-09 03:30:55 - last edited 2021-04-16 10:31:40

Posts: 2

Helpful: 3

Solutions: 1

Stories: 0

Registered: 2021-03-09

TL-605 firewall and virtual server?

2021-03-09 03:30:55 - last edited 2021-04-16 10:31:40

Model: ER605 (TL-R605)

Hardware Version: V1

Firmware Version: 1.01

Hello,

I can't seem to open ports for my servers. I have the NAT port forwarding entries, but the ports are closed for the WAN side. I have looked all around the GUI and can't seem to find any real firewall rules. After searching it looks like I need to use the virtual server feature. But for the life of me, I can't find that either. It's on the datasheet and I am using the Omada controller. It should be available right?

1 Accepted Solution

Grohk

LV1

2021-03-10 20:47:39 - last edited 2021-04-16 10:31:40

Posts: 2

Helpful: 3

Solutions: 1

Stories: 0

Registered: 2021-03-09

Re:TL-605 firewall and virtual server?-Solution

2021-03-10 20:47:39 - last edited 2021-04-16 10:31:40

@Grohk

Fixed this problem. It was an issue with ip passthrough from my modem.

I unadopted the gateway and went in through the web admin interface. Still wasn't working, so I looked at the modem. The NAT rule in the controller worked fine once I got that sorted, even though it wasn't labelled Virtual Server.

TL-605 firewall and virtual server?

TL-605 firewall and virtual server?

Information

Voters 0

Tags