I have the following configuration:

Gigbit Cable Modem - (tests 940 - 960 down with solid 40 up when direct connect with PC)

Connected to a TL-R600VPN V4.0 via WAN port

Connected to a TL-SG1008MP 8 port PoE Switch Via LAN port

Connected to 6 EAP225-Wall and 1 Omada OC200 Via Switch LAN PoE Ports

I get gig from the modem to the router, gig from the router to the switch (The 1000 is lit green on the switch for that port)

BUT

I get 100Mbs only on the other 7 ports (6 for the AP's and 1 for the OC200).  Also, if you plug in a PC Ethernet directly into the port on the AP you also only get 100 so not a "wireless" issue.

I have tested each port and they all go 1000 when connected to the router as the input (basically I unplugged all AP's and just went port by port with the incoming lan from the router to test and they all negotiated at 1000)

All AP cables are cat 6, all less than 75 meters. All patch cables are CAT 7 less than 1 meter.

I have redone the RJ45 on all cables both in 568A and B,  and also tested with a 6ft factory made cable (568B) direct to AP from the switch (stood there and held it in my hand) and still, only 100Mbs.

Why????  What am I doing wrong?  I have all negotiation set on "auto" and it is an unmanaged switch so I cannot force 1000 regardless.  I even purchased a T1500G-10MPS to see if the original switch was defective or inadequate and I had the same issue so I returned it. (it is also unable to force 1000 or at least i could not figure out how to do it)  I cannot plug the AP's directly to the router to test because no PoE but i checked all settings in the OMADA software and I ensured no "limits" are set.

What gives?

Any help would be most appreciated.