TL-ER6020 IPsec NAT Transversal

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-ER6020 IPsec NAT Transversal

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AlbertoPaulino

2020-01-13 14:27:51 - last edited 2021-04-19 11:35:37

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-01-13

TL-ER6020 IPsec NAT Transversal

2020-01-13 14:27:51 - last edited 2021-04-19 11:35:37

Model: TL-ER6020

Hardware Version: V2

Firmware Version: 2.0.2 Build 20180702 Rel.59031

I need to set up a site-to-site vpn between the TL-er6020 and a 1000C fortigate. Fortigate administrator sent me an IP 172.21.1.56 for use with transverse NAT. But I didn't find where to configure this on the TL-er6020. Can anybody help me ?

Best Regards

Alberto

1 Reply

Andone

LV4

2020-01-15 02:02:25 - last edited 2021-04-19 11:35:37

Posts: 747

Helpful: 115

Solutions: 18

Stories: 0

Registered: 2018-07-19

Re:TL-ER6020 IPsec NAT Transversal

2020-01-15 02:02:25 - last edited 2021-04-19 11:35:37

NAT Transversal is the feature that designed to solve the problems inherent in using IPSec with NAT. As I know, TP-Link VPN router enable this feature by default. IPsec VPN need to set many parameters. You can refer to https://www.tp-link.com/en/support/faq/2163/ . And 172.21.1.56 is not a public IP address. Maybe your router is behind a NAT. You need to open UDP 500 and UDP 4500 on the NAT device. And we should fill in the public IP address at remote gateway item.

TL-ER6020 IPsec NAT Transversal

TL-ER6020 IPsec NAT Transversal

Information

Voters 0

Tags