I just recently upgrade my X20 to the PX50 and in doing so I decided to keep a couple of the existing X20 nodes to expand coverage in my home. The initial setup was one node on the first floor and two

Just bought an AXE5400 (3-pack XE75) new, installed around my house, works fine except for three issues... 1. I have some devices that can operate on 2.4 or 5 GHz but I want them to only use 5. In the

Deco does not recognize Ethernet cable on unit supported by WiFi - main system connect by Ethernet cable but tied to use Ethernet in a down stairs deco unit & it did not work- Do the other unit allow

i have a mixed network of M4s (three) and XE75 (two) but the walls (and floors) are very thick in our "eco build" super insulated house! so the two M4s on the 2nd and 3rd floors have a weak signal bet

Hi, I have an issue with an IPV6 DNS Settings when on Wired conenction to a satalite node. I am in AP Mode and there are no IPV6 settings on the router. Also on WiFi I get IPv4 DNS Only. To be honest

On my parental logs are a few just IP addresses that I cannot reverse search. Just curious if I should be concerned 20.15.0.56 24 158