HS210 3 way installation issues (lights click on and off)
Hello everyone.
I'm having some issues wiring in two HS210 switches in a 3 way setup. 1 at the top of my basement stairs and one at the bottom. The switches control about 8 sets of fluorescent lights in case that matters.
Here's my setup:
2 switches
Both switches look identical on the inside:
Bare copper ground wired directly to swtich
White Neutrals connected with a wire nut in back of box
1 red traveler connected to switch
1 black traveler connected to switch
1 black live wire connected to switch
When I wire the switches in following the directions, here's what happens:
The switch will continuously "click" and the lights will turn on and off about every second
I've also tried doing just one HS210 in each location and things change a little bit. If I do this, when my dumb switch is on, the HS210 gets no lights on the switch and does nothing when I press it. When I turn my dumb switch off, the HS210 will then again start clicking and turning lights on and off.
Any help anyone can offer would be very helpful. Thank you!