Only 1 light of 3 works

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Only 1 light of 3 works

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Only 1 light of 3 works
Only 1 light of 3 works
2020-11-12 17:48:42 - last edited 2020-11-16 15:59:45
Model: HS200  
Hardware Version:
Firmware Version:

Wired up the HS 200 for my 3 outdoor lights that are all controlled by 1 single pole switch.  All the wires for the HS 200 were properly connected to the circuit and the HS 200 could be linked etc.  But the HS 200 switch would only turn on and off one of the 3 lights controlled by the switch. Have power to all the black wires as expected.

Reinstalled old single pole switch and it works all the lights just like it did before.  

Any idea as to what the problem is?

  0      
  0      
#1
Options
1 Accepted Solution
Re:Only 1 light of 3 works-Solution
2020-11-12 21:28:57 - last edited 2020-11-16 15:59:45
Problem solved - had to locate the ganged neutral and connect the HS 200 neutral to it - then connect the power to one black side of the HS 200 and the other 2 black leads to the other black side of the HS 200. Thanks for your interest
Recommended Solution
  0  
  0  
#5
Options
5 Reply
Re:Only 1 light of 3 works
2020-11-12 18:01:25

@golfrowood  Do you have a picture of the old switch wiring, and the wall box?

  0  
  0  
#2
Options
Re:Only 1 light of 3 works
2020-11-12 20:49:32
Here is a picture of the functional original switch - Not sure its going to show up so trying 2 formats /Users/home/Desktop/IMG_3510.jpg /Users/home/Desktop/outside lights switch.pdf
  0  
  0  
#3
Options
Re:Only 1 light of 3 works
2020-11-12 20:58:13

@golfrowood No picture.

If you look at the line just above the text box while responding, there is a icon of a mountan with a dot in the upper left corner.

Click on that and attach the .jpg

  0  
  0  
#4
Options
Re:Only 1 light of 3 works-Solution
2020-11-12 21:28:57 - last edited 2020-11-16 15:59:45
Problem solved - had to locate the ganged neutral and connect the HS 200 neutral to it - then connect the power to one black side of the HS 200 and the other 2 black leads to the other black side of the HS 200. Thanks for your interest
Recommended Solution
  0  
  0  
#5
Options
Re:Only 1 light of 3 works
2020-11-12 21:38:09

@golfrowood Good to hear you got it working.

  0  
  0  
#6
Options