Kasa Smart Plugs
When the power goes out on a ES10, what state does the plug revert to? ON or OFF, or last setting? Does the firmware/app support an optional setting to set whether it is ON or OFF or last setting afte
Feature RequestSetup and ConfigurationSmart Actions
By
szchren
1Helpful
148Views
Hi all I have 2 KP125M plugs and the kasa app. I was hoping to run a schedule when I am away from my house. for example turn a plug on at 11:30pm 'only' when I am not home. I can get the smart action
Smart ActionsScheduleFeature Request
By
Number1Ears
0Helpful
199Views
I have a "different" use case. I want to use my smart plug with a sump pump to find out how often the pump runs. I don't care about energy consumption per-se, just whether the pump is drawing power an
Feature RequestEnergy Monitoring
By
SteveM56
0Helpful
279Views
This is a general scheduling question - Is there a way to set up a schedule and then be able to activate/deactivate it? It seems that once you create a schedule it is Active. I'd like to create a sche
Feature RequestSchedule
By
PHugger
· Latest post 2023-06-21 10:55:57
by Solla-topee
0Helpful
422Views
I would like to see an automated Reboot/Power Cycle function added to the Smart Plugs. If I have a Router or Access Point connected to a Smart Plug and want to power cycle the device (say one where it
Feature RequestSmart ActionsRemote ControlSchedulePower Cycle
19Helpful
1282Views
Are there any plans to introduce a 220 volt version of the latest smart plugs (e.g., KP125M or similar) in the US market? Smart plugs sold outside North America would do so, even if the plugs aren't t
Energy MonitoringFeature Request
0Helpful
374Views
I just switched from Belkin Wemo plugs/switches, and hoping to find a way a Kasa GROUP can be set for vacation/away mode rather than individual plugs/lights. I have 9 lights in total that I would want
Feature Request
By
MacMaven234
· Latest post 2023-02-22 19:47:35
by Carl
0Helpful
420Views
Simple question: how do I monitor the energy usage of the usb ports on the HS300 power strip? The app doesn't seem to have an option to make this info available but I could just be missing the obvious
Energy MonitoringFeature Request
0Helpful
692Views
I use several HS100 units (HW 2.0/FW 1.5.1) for different purposes, and if I accidentally turn one of them off, I can turn it on again with no problem. Except for the one unit that I use to control th
Feature Request
By
TheWaterbug
· Latest post 2022-11-08 01:45:47
by Riley_S
3Helpful
526Views
Find it hard to believe, hoping its an obvious setting/setup somewhere, but one woudl think you woudl want the "away" option to work overnight - ie sunset to sunrise. Option unavialble. Only way I see
Feature Request
0Helpful
441Views