Home Network Community > All Threads > Archer C1200 - How to share with a computer not connected to the router
< All Threads

Archer C1200 - How to share with a computer not connected to the router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer C1200 - How to share with a computer not connected to the router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer C1200 - How to share with a computer not connected to the router
Archer C1200 - How to share with a computer not connected to the router
2017-02-17 03:23:52
Model :

Hardware Version :

Firmware Version :

ISP :

I have an AT&T Uverse router. One computer is directly connected to the router, and the Archer C1200 is connected to another port. Three computers are connected to the Archer C1200. What do I need to configure on the Archer to share folders between a computer connected to it and the computer that is connected directly to the Uverse router?
  0      
 
  0      
 
#1
Options
3 Reply
Re:Archer C1200 - How to share with a computer not connected to the router
2017-02-17 09:06:54
It seems that you're under a double-NAT network environment. Every router acts as an NAT device and clients separated by an NAT device will not be able to communicate with each other.
For a solution, it's recommended to select one of the routers as the main one, and the other purely works as an access point to provide wired&wireless access only.
Here is an FAQ for how to:
http://www.tp-link.com/en/faq-1199.html
  0  
  0  
#2
Options
Re:Archer C1200 - How to share with a computer not connected to the router
2017-02-17 10:52:17
I'm unable to get step 3 to work (changing the IP address). When I log into my Uverse router, I see that it has:
DHCPv4 Start Address 192.168.1.64
DHCPv4 End Address 192.168.1.253

Step 3 says "Change the LAN IPv4 to one on the main router’s subnet", so I tried to set it to 192.168.1.101, but I get the error message "WAN IP address and LAN IP address can not be in the same subnet"
  0  
  0  
#3
Options
Re:Archer C1200 - How to share with a computer not connected to the router
2017-02-17 13:38:53

bosuch wrote

I'm unable to get step 3 to work (changing the IP address). When I log into my Uverse router, I see that it has:
DHCPv4 Start Address 192.168.1.64
DHCPv4 End Address 192.168.1.253

Step 3 says "Change the LAN IPv4 to one on the main router’s subnet", so I tried to set it to 192.168.1.101, but I get the error message "WAN IP address and LAN IP address can not be in the same subnet"


Please pay attention that once you set up the router as an access point, you don't need to plug the WAN port anymore. It seems that the WAN port is still connected to the Uverse router. Please check the step 5.
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 1136

Replies: 3

Related Articles
Archer C1200 Problem
870 0
Archer C1200 and CNAME
1235 1
Archer C1200 print over VPN
394 0
Archer C1200 Translation mistake
670 0
Static Routes on Archer C1200
2593 1
Archer C1200 Packet Loss
1460 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.