Hi,

I've just spent 3 days trying to get a new gen2 Starlink router to work with my CPE 210 units, one configured as an AP, the other in client mode.

I use them to take internet to another building about 120 meters away. The usual set up has been, router - AP ---------- maxtream ------Client - Ethernet Switch.  This has worked just fine until I installed the Starlink gen 2 router. It's a little different because the gen 2 router has no Ethernet ports so I used an Apple AirPort Express in client mode to camp on the the Starlink WiFi and provide an Ethernet connection to the CPE210 AP. So I have, SL router ------ AirPort Express - CPE210AP-------maxtream------CPE Client - Ethernet Switch, but it doesn't work. There seems to be a connection to the SL router and it assigns IP addresses to connected devices but doesn't give them access to the internet. If I turn off Maxtream I can camp onto the CPE210 AP and the internet works fine, but after the CPE Client it does not.

An ideas would be appreciated.

Kev