Mesh 6e upload nonexistent
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Mesh 6e upload nonexistent
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I updated my firmware and now have zero upload speed. DL runs at 650mbps. Modem unable wifi running normal speeds. Tried all forum solutions but can get and upload speed. Swapped cables etc.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Can you double-check your model? The E4 does not support the 6GHz network.
If you modem is running its own wireless signal, it is likely a Gateway and needs to be placed in Bridge Mode or in IP Passthroguh Mode.
How long has your network been running prior to updating your firmware?
Is there more than one device connected to your Gateway?
- Copy Link
- Report Inappropriate Content
@Riley_S it's a XE75 model mesh. Running 1.2.8 .
been working fine for a month plus since firmware update. Just stopped. Since my original email, did a factory reset of router. Still get .02 upload but normal download. This modem config no change. Been running that for over one year
- Copy Link
- Report Inappropriate Content
Hi, May I know who is your internet service provider?
Was the original firmware 1.2.7 before updating to 1.2.8?
Can you share some speedtest screenshots with us?
Wait for your reply and best regards.
- Copy Link
- Report Inappropriate Content
@David-TP I'm using Optimum and was on 1.2.7.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@David-TP this is a Speedtest from the modem directly.
- Copy Link
- Report Inappropriate Content
@David-TP hi. Any luck with solving my problem?
- Copy Link
- Report Inappropriate Content
@Budinct please confirm your router model. As stated above, the Deco E4 does NOT repeat NOT have WiFi 6e, the E4 ONLY has Wifi 5.
- Copy Link
- Report Inappropriate Content
@Richardj186 hi it's XE75 with 6e and latest firmware
- Copy Link
- Report Inappropriate Content
@Budinct thanks!
I had this happen once with my BE85's, and while a pain, this method fixed it (but don't know why it fixed it).
1. Unplug modem and all XE75's from power.
2. Wait 60 seconds, and then plug modem back in to power.
3. After modem finishes booting, plug in main XE75 which is connected to the modem.
4. After the main XE75 is back online, plug in the other units.
5. Wait a half hour or so after they all boot so that network load is auto balanced between them all, do another speed test.
Let us know if that helped.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 1015
Replies: 14
Voters 2
