BUG in RE200 V4 - Can't set correct time!
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Per thread at https://community.tp-link.com/us/home/forum/topic/105635
which was closed without a resolution, the correct time can't be set on TPL RE200 V4 w/ firmware 1.0.8 Build 20210916 Rel. 59255
Unplugging the RE200 causes the date and time to reset to 01/01/2021 00:00:00
Changing the timezone only adjusts the hour by the selected timezone offset amount.
The RE200 has time-dependent functionality which is rendered useless by not being able to set the correct time manually.
If the time is actually set automatically, this should be configurable - there may be no internet connection or a custom/internal NTP server may need to be set by the user.
- "Before enabling the LED Control, make sure System Time is correct."
- "Before enabling Power Schedule, please make sure the System Time is correct."
- System Log shows incorrect timestamps.
Hello @TP_Device_User
After the reboot of range extender, the time settings will be reset.
After plugging the range extender back in, make sure the extender has fully booted up ( for a few min)and got an internet connection.Then manually select the Time zone and get the correct time at that time?
You could also try to adjust the firewall settings on the router and see if that makes any difference, sometime the firewall may be affecting RE get the correct time from the NTP server.
If that's not the case, please share a photo of the time settings on the range extender.
What is the model of Wifi router and network topology.
