Best practice for doorbell and cameras (or how you folks did it)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Best practice for doorbell and cameras (or how you folks did it)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Best practice for doorbell and cameras (or how you folks did it)
Best practice for doorbell and cameras (or how you folks did it)
2022-08-27 13:11:14
Model: Deco X20  
Hardware Version:
Firmware Version:

Howdy all,

 

I'm about to move into a new home and will be setting up the usual doorbell, thermostat and a couple of camera's (all wifi).  I did a search the forums for camera's then doorbell and saw were some folks were setting them up on the guest network but also thought I noticed that prohibited access while you were "away".  What is a safe recommendation for setup of these on your home wifi?

 

Along those same lines since most all those products seem to only work on 2.4g is WP3A-Personal + WPA2 what is recommended?

 

Thanks for any thoughts and if I've missed anything that would help let me know.

  0      
  0      
#1
Options
1 Reply
Re:Best practice for doorbell and cameras (or how you folks did it)
2022-09-01 03:35:17

  @Runningp 

Most of smart home devices are 2.4ghz only and Deco, unluckily could not separate 2.4ghz from 5ghz if you don't use guest network.

So the best option would be a standard router if you are not a fan of mesh network. Archer AX11000 sounds nice and I see it has some discounts occasionally on their official websites.

Deco mesh works fine for me. I have Deco M9 plus and use 2.4ghz as the main, 5ghz as the guest since I don't need my 5ghz devices communicate to each other. Before I tried 2.4g+5g mixed network for a while, it seemed nice for my smart home devices.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 322

Replies: 1

Related Articles