Home Network Community > All Threads > Not getting full WiFi speed (TP-Link AX3000 A55)
< All Threads

Not getting full WiFi speed (TP-Link AX3000 A55)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Not getting full WiFi speed (TP-Link AX3000 A55)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Not getting full WiFi speed (TP-Link AX3000 A55)
Not getting full WiFi speed (TP-Link AX3000 A55)
2022-05-15 19:21:52 - last edited 2022-05-17 03:13:08
Model: Archer AX55  
Hardware Version: V1
Firmware Version: 1.0.7 Build 20220120 rel.74083(5553)

Just got a TP-Link AX3000 (Archer A55).  I have 1 GBps internet, but can only get ~550 Mbps to my iPhone 13 Pro Max (which has 802.11ax).  It gets ~980 Mbps through internet, but almost half that through Wi-Fi.  I scanned the air and made sure there was nothing ejde that might be interfering (there wasn't).  Anyone have this model and get close to an actual 1 Gbps?  Thinking about sending it back and getting a different one.

 

I should note I have a docsys 3.1 modem and using CAT7 Ethernet cable between modem and router.  I'm also using a 160 bandwidth channel.

  0      
 
  0      
 
#1
Options
2 Reply
Re:Not getting full WiFi speed (TP-Link AX3000 A55)
2022-05-16 23:35:28

  @KD2022 

Given the speeds that you are indicating, it looks as though your phone is not connecting to the 5Ghz network and is instead only connecting to the 2.4 GHz network. The speed limit for that band of Wi-Fi is approximately 575 Mbps. Is there any chance that you can make sure that both of the networks are enabled in the control panel for the Archer? While you are in the menus, I would also check to see if there is an update available for your device.

If you take the test in the same room as the router, do you have the same speeds, or does the phone connect to the 5Ghz band?

Check out the Latest: Getting Started with EasyMesh and TP-Link New Tablet Mode for the Tapo App Comparing the Latest Tapo Doorbells
  0  
  0  
#3
Options
Re:Not getting full WiFi speed (TP-Link AX3000)
2022-10-30 02:46:59

  @Riley_S 

Im having the same problem as OP.

 

Both bands are enabled in control panel. I did try to seperate bands and then only connected to 5ghz one but still my speed were limited around 550mbps.

Via ethernet I can get max speed around 950mbps always thought.

 

It's on latest firmware, no current updates pending.

 

Tested in same room as router and in other rooms as well, same issue.

 

Thanks for the help in advance.

  9  
  9  
#4
Options

Information

Helpful: 0

Views: 2121

Replies: 2

Related Articles
Archer C9 V1 not getting full wifi speed
816 0
DECO W4500 not getting full speed
832 1
TP link AC 1200 not getting full ethernet speeds
3582 0
tp link archer ax3000 not getting the speeds that I wanted
576 0
Archer C7 - Not getting full speed unless I put it AP mode.
166 0
Archer AX3000 I am not getting my 1gbs speed
1527 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.