Satellite Deco Blinking Red while trying to setup again

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Satellite Deco Blinking Red while trying to setup again

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Satellite Deco Blinking Red while trying to setup again
Satellite Deco Blinking Red while trying to setup again
2022-03-02 12:01:05
Model: Deco E4  
Hardware Version: V8
Firmware Version: 1.5.4 Build 20211101 Rel. 75384

I have two Deco E4s (one main and one satellite). I was deleting my Decos from the network after changing my ISP. I unplugged my satellite Deco and then removing it from my network. Then, I removed the main one from my network before unplugging it. I proceeded to make a new network with the main one and it was successfully added. But then when I wanted to add my satellite Deco, it kept pulsing the red LED. Is it because I unplugged it before removing it from my network? How do I fix this?

  0      
  0      
#1
Options
1 Reply
Re:Satellite Deco Blinking Red while trying to setup again
2022-03-02 23:56:21

  @mattmaxtane 

 

 

 

The suggestion would be to hard reset the unit and then once you see the inidcator light plusing blue you can then setup attempt setup again. 

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 658

Replies: 1

Related Articles