Archer C7 AC1750 - Wireless Access Point?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer C7 AC1750 - Wireless Access Point?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer C7 AC1750 - Wireless Access Point?
Archer C7 AC1750 - Wireless Access Point?
2021-11-19 01:35:04 - last edited 2021-11-25 07:54:19

I have 2 Archer C7 AC1750 mesh wifi routers, and want one to be setup as an access point.  But, it appears the 2 routers need to be connected via an ethernet cable.  Is there any way to set this up as a wireless connection?  I am doing the same with an old Netgear router with one of the Archer C7's (as a repeater, technically), but the connection is not the greatest, so I went and bought the second one, hoping the connection would be better. 

Thanks

  0      
  0      
#1
Options
1 Accepted Solution
Re:Archer C7 AC1750 - Wireless Access Point?-Solution
2021-11-19 09:45:05 - last edited 2021-11-25 07:54:19

Hello @paruby 

1> For stable connection, we  would recommend using a second router in AP mode using an Ethernet cable:

Router<Ethernet>router2 (AP mode)

2> Certain models of router support WDS bridging and second router could use as a repeater, this is not very recommended as the set-up is a bit complicated and sometimes got compability issue, you might give it try: 

How to configure WDS function on TP-Link Wireless Routers (new logo)?

 

By the way you wish to build a Mesh, the mesh is build between OneMesh router and  OneMesh extender/powerline devices, not between 2 routers,  you might get a OneMesh range extender if you prefer to extend signal through Wi-Fi:

Several questions about the OneMesh™ and Mesh

 

Recommended Solution
  3  
  3  
#2
Options
1 Reply
Re:Archer C7 AC1750 - Wireless Access Point?-Solution
2021-11-19 09:45:05 - last edited 2021-11-25 07:54:19

Hello @paruby 

1> For stable connection, we  would recommend using a second router in AP mode using an Ethernet cable:

Router<Ethernet>router2 (AP mode)

2> Certain models of router support WDS bridging and second router could use as a repeater, this is not very recommended as the set-up is a bit complicated and sometimes got compability issue, you might give it try: 

How to configure WDS function on TP-Link Wireless Routers (new logo)?

 

By the way you wish to build a Mesh, the mesh is build between OneMesh router and  OneMesh extender/powerline devices, not between 2 routers,  you might get a OneMesh range extender if you prefer to extend signal through Wi-Fi:

Several questions about the OneMesh™ and Mesh

 

Recommended Solution
  3  
  3  
#2
Options

Information

Helpful: 0

Views: 1071

Replies: 1

Related Articles