Home Network Community > All Threads > AX1800 NAT forwarding / Port Forwarding not working after reboot
< All Threads

AX1800 NAT forwarding / Port Forwarding not working after reboot

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AX1800 NAT forwarding / Port Forwarding not working after reboot

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
AX1800 NAT forwarding / Port Forwarding not working after reboot
AX1800 NAT forwarding / Port Forwarding not working after reboot
2021-05-21 11:21:37
Model: Archer AX1800  
Hardware Version: V1
Firmware Version: 1.3.0 Build 20210304 rel.12099(5553)

I configured automatic reboots recently.  After an automatic reboot, the ports forwarded from NAT forwarding are no longer forwarding.

 

They still show in the configuration. 

 

I turn off one with the toggle control, wait a sec, then turn it back on.  The NAT forwarding starts to work again.

  2      
 
  2      
 
#1
Options
2 Reply
Re:AX1800 NAT forwarding / Port Forwarding not working after reboot
2021-05-24 12:48:52
Do you have UPnP on or off?
  0  
  0  
#2
Options
Re:AX1800 NAT forwarding / Port Forwarding not working after reboot
2021-05-24 13:29:58

@ArcherC8 

 

I have UPnP turned off.

 

The issue re-appeared without a reboot when I disconnected the cable, then reconnected the cable.

 

I turned on UPnP and will update if the issue still occurs after next reboot or cable disconnect.

  0  
  0  
#3
Options

Information

Helpful: 2

Views: 1884

Replies: 2

Related Articles
NAT forwarding
313 0
Port forwarding
805 0
Port forwarding
6036 0
Port forwarding
109 0
Port forwarding
76 0
Port Forwarding does not open any ports at all
1355 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.