OK ...

So here is my issue, Sunday nite Deco app says new firmware to install, so I started the install. The units downloaded and installed the FW then rebooted. Now all the Decos have solid red lights. I rebooted the Main Deco still no green. So I factory reset the Deco and went through the setup. The unit had flashing blue light then on the app it found my router and configured my neteork type (dynamic IP) then it ased me to setup the WIFI network which I did. When the phone connected to the unit got the red light again. Went into the Deco and under the IPv4 no IP address. I then connected a PC to mu modem and was able to get an IP addy. Tried another Deco same results.

To make sure it was not internet provider, I had an old TP-link 1470. I connected it up and the network is now fully functional.

SO anybody got a clue as to why this FW  upgrade did this? I guess I am going to try and reload the firmware manually but has anyone else had this issue????