AX6000 firmware update broke Link Aggregation

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AX6000 firmware update broke Link Aggregation

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

jeffriechers

2021-03-01 22:16:28 - last edited 2021-11-23 02:42:14

Posts: 2

Helpful: 2

Solutions: 1

Stories: 0

Registered: 2021-03-01

AX6000 firmware update broke Link Aggregation

2021-03-01 22:16:28 - last edited 2021-11-23 02:42:14

Model: Archer AX6000

Hardware Version: V1

Firmware Version: 1.2.1 Build 20210205 rel.12759

I just recently updated my AX6000 for the OneMesh capabilities, however after the update my NAS device that I had connected to the Link Aggregation ports no longer seems to be responding. I have tried disabling the Link Aggregation, and then re-enabling to no avail.

I am going to attempt to reset the networking on the NAS to single port, but wanted to see if anyone else has seen this issue with this device and firmware update.

1 Accepted Solution

jeffriechers

LV1

2021-03-02 13:32:12 - last edited 2021-11-23 02:42:14

Posts: 2

Helpful: 2

Solutions: 1

Stories: 0

Registered: 2021-03-01

Re:AX6000 firmware update broke Link Aggregation-Solution

2021-03-02 13:32:12 - last edited 2021-11-23 02:42:14

So I disabled and re-enable LAG again and this time it worked. So looks like if you lose access to your LAG devices just disable reboot and enable and reboot a few times and it goes good.

Information

Helpful: 0

Replies: 1

AX6000 firmware update broke Link Aggregation

AX6000 firmware update broke Link Aggregation

Information

Voters 0

Tags