No IPV6 on new AD7200

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

No IPV6 on new AD7200

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
No IPV6 on new AD7200
No IPV6 on new AD7200
2018-01-19 13:18:20
Model :

Hardware Version :

Firmware Version :

ISP :

Despite the fact that I've followed all the instructions to enable and configure IPV6, every time I check with test-ipv6.com it keeps saying NO connectivity. On the status page it shows an IPV6 address issued by my ISP (router is set to Dynamic IP SLAAC DHCPv6). This is not an ISP issue because a few days ago I had an Asus AC3200 router that died on me, and on that one IPV6 worked perfectly. Same cable modem, same ISP, different router. What's going on here?
  0      
  0      
#1
Options
5 Reply
Re:No IPV6 on new AD7200
2018-01-21 05:26:40
I just installed a AC2600 and have the same issue. I have updated to latest firmware reset cable modem and rebooted router numerous times. Ipv6 address shows in router status but fails online test.
My old linksys router connected to Ipv6 just fine
  0  
  0  
#2
Options
Re:No IPV6 on new AD7200
2018-01-21 07:12:10
Change SLAAC to DHCPv6 and reboot.
  0  
  0  
#3
Options
Re:No IPV6 on new AD7200
2018-01-21 23:44:37


Here is a screenshot of ipv6 section, with google dns selected it was the same with the Isp selected dns.
I dont have a clue why its not working.
My old router worked fine and not 6to4 tunnel as you can see DHCPv6 is selected in advanced
.the upper internet connection type is Dynamic Ip
Any help here?
is
  0  
  0  
#4
Options
Re:No IPV6 on new AD7200
2018-01-21 23:56:37
Aha! figured I would just play around, and Changed Prefix Delegation from the default of disable to enable and that worked
I now have full ipv6
Instructions didn't help ,this should be made known

  0  
  0  
#5
Options
Re:No IPV6 on new AD7200
2018-01-22 04:36:17

igortrix wrote

Change SLAAC to DHCPv6 and reboot.


Fortunately a knowlegeable person got back to me. On the AD7200 go to the IPV6 tab, click "Advanced" and then enable Prefix Designation.Problem solved, IPV6 works like a charn. My other settings are DHCPV6/LSAAC on the WAN side and SLAAC+Stateless DHCP on the LAN side. My ISP is Spectrum and I have a CM500 Netgear cable modem.

As you guys know, IPV6 is the future and will eventually replace IPV4. Why this is disabled by default is beyond my comprehension.
  1  
  1  
#6
Options

Information

Helpful: 0

Views: 930

Replies: 5

Related Articles