ATT Fiber BGW320 - Has anyone truly been able to get IP Passthrough to work?
I bought the Deco routers to replace my aging Orbi routers which I had switched to being access points in the years past because they kept locking up.
My goal with this purchase was to use the Deco as my true router so I can have parental controls and change my DNS to an internal machine (PiHole) to block ads on the network.(The BGW320 does not allow custom DNS servers)
The problem I am facing is that the Deco router is not being given a true external IP address from the ATT Router, the "IP Passthrough" function does not appear to actually do anything.
On the BGW I have changed the following
1) disabled wifi
2) Turned off all firewall functions
3) Disabled packet filters
4) Enabled IP Passthrough
The Deco is still being served up a 192.168 IP address from the ATT router. Which is causing network slowness and the dreaded double NAT
Things that stand out
1) If you look online about this.... half of the posts say it's easy just set up IP passthrough. The other half say it's not possible.
2) I believe routers have 2 MAC addresses? The sticker on the bottom of the Deco state that the MAC address ends in "50" but in the BGW320 it sees it ending in "51". I've tried both. neither seem to work
Has anyone actually been able to get this to work? Or is it time to give up and return these Deco routers?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@SteveMat Try it! Look, I've have AT&T for many years, they never changed my IP Addres, not a sing time. The only time they did is when I moved to a new part of town and had to get a new set up. Even after that, I kept the same IP Address since.
- Copy Link
- Report Inappropriate Content
@SteveMat I would definitely suggestion not to plug anything into the bgw, only the deco. Also I decided to run without ipv6 and noticed a lot of drops have stopped.
- Copy Link
- Report Inappropriate Content
@kriihz I generally do not get any drops, just psuedo randomly when either Gateway reboots or the Deco, it gets a local IP Address and not the WAN address. As mentioned, I can reproduce the problem with either a Deco attached or my HP Laptop - so pretty sure this is a AT&T Gateway/Nokia issue and not a TP-Link issue.
- Copy Link
- Report Inappropriate Content
@SteveMat It is ATT, I have two XE75 Pro and I have had some much issues, I finally went and put my DHCP into dynamic so it would stop kicking the mac,the connections from the gateway would drop randomly as well, I did a reset then I went in and reset all the connections again with the IPs and everything in the gateway, it's been a few days and have not seen a drop
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@SGalbincea Seems to WAN Address seems to stick until the Gateway and/or Deco is rebooted. I can sometimes reboot the Deco once or twice and it will get the WAN address or if I change to PPPoE and back to Dynamic for Internet Connection, that always gets it to grab a WAN Address.
- Copy Link
- Report Inappropriate Content
Thanks for this thread! I went through a number of advice here...
I run a Deco BE95 myself behind a BGW320-505.
I did all the things on the BGW320-505 to passthrough the public IP, not filter any data requests via the Firewall, etc.
On the Deco side, what ultimately worked for me was changing dynamic IP to a static one. Keeping all other variables the same, but changing the IP from the internal IP to my public IP that ATT assigned me.
- Copy Link
- Report Inappropriate Content
@FiberKid Your default gateway and (probably) subnet mask may be off...
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 4690
Replies: 48
Voters 1
