Log into the Web-based Interface of Wireless Access Point in Client mode

WLAN3000

2024-10-07 13:30:50 - last edited 2024-10-07 14:08:47

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-10-07

Log into the Web-based Interface of Wireless Access Point in Client mode

2024-10-07 13:30:50 - last edited 2024-10-07 14:08:47

Tags: #Client Mode

Model: TL-WA1201

Hardware Version: V3

Firmware Version: 3.6

I have the access point configured in client mode for my printer to connect wirelessly to our network. This works. My question is how do I access the web based interface of the access point while it is connected to the printer.

http://tplinkap.net does not work.

In the menu of my router I find the IP address that the access point generates. I type this IP in my browser and it leads me to do the interface of my printer. There is no other IP address that could be for the exit point itself.

1 Reply

Ryan

2024-10-08 16:03:22

Posts: 206

Helpful: 28

Solutions: 5

Stories: 1

Registered: 2018-11-01

Re:Log into the Web-based Interface of Wireless Access Point in Client mode

2024-10-08 16:03:22

Hi @WLAN3000

Welcome to the community!

If the TL-WA1201 is configured in Client Mode, then the only method to access its web GUI would be one of two ways:

1. Connect a PC (e.g., laptop) directly to its Ethernet port, then try to access its Web GUI URL.

2. Perform a factory reset on the device (press and hold the Reset button for at least 10 seconds). Once it is in its default state, you should see its default SSID, be able to connect to it, and then re-configure it. This shouldn't be too involved since Client Mode is a relatively simple setup.

Check out the Latest: Getting Started with EasyMesh and TP-Link New Tablet Mode for the Tapo App Comparing the Latest Tapo Doorbells

Log into the Web-based Interface of Wireless Access Point in Client mode

Log into the Web-based Interface of Wireless Access Point in Client mode

Information

Voters 0

Tags