XE 5300 Main router turned red after upgrading firmware to 1.4.1
XE 5300 Main router turned red after upgrading firmware to 1.4.1
Tried reset. Failed to roll back to previous firmware version.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
The guidance provided in the post below is intended for use only under the following circumstances:
1. You are unable to revert your firmware version using the instructions outlined above.
2. One of your Deco units has ceased functioning.
https://www.tp-link.com/us/support/faq/2958/
- Copy Link
- Report Inappropriate Content
I followed the wireless way of upgrading firmware but it didn't let me downgrade.
I followed "HTTP Uboot Method" using a PC connected to Ethernet port but neither of 192.168.0.1 or 192.168.68.1 worked. Please help.
- Copy Link
- Report Inappropriate Content
I highly suggest you open up a ticket with support and see if they can help you because I am all out of ideas on this
Follow the directions in the post below to open up a ticket
https://community.tp-link.com/us/home/forum/topic/694474.
- Copy Link
- Report Inappropriate Content
@HelpFixDecoApp
Thank you. I'm filing a ticket.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
I was able to downgrade the firmware. And the main router was still red. I downgraded one of the satelite routers and used that as main. It worked. All 3 routers are connected to Internet now.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 345
Replies: 7
Voters 0
No one has voted for it yet.