Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > Not getting max up/down speeds from my router

< Deco

Not getting max up/down speeds from my router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Not getting max up/down speeds from my router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Acshaw80

2024-01-09 00:53:48

Posts: 2

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2024-01-09

Not getting max up/down speeds from my router

2024-01-09 00:53:48

I just installed the BE85 and I don't appear to be getting the max download/upload speeds that I have from my ISP.

i have 2gb fiber from ATT but when I do a speed check on my deco router through the deco app it maxes out at 952mb up and down.

the cable that runs from my modem to my deco base unit is plugged into the 10gb port.

I confirmed on my modem that I'm actually getting about 2.5gb down.

i went into QOS and adjusted the speed to 10000 but this hasn't helped.

Is there something else I need to try to get the full speed from my ISP?

4 Reply

David-TP

2024-01-09 03:39:55

Posts: 12476

Helpful: 1725

Solutions: 1200

Stories: 9

Registered: 2020-04-14

Re:Not getting max up/down speeds from my router

2024-01-09 03:39:55

@Acshaw80

Hi, did it help if the ATT modem is connected to the 2.5 GHz port on the BE85?

Please also make sure the Ethernet cable between the ATT modem and BE85 is CAT6 and above.

If the speed was capped at 952m/s again, could you please help me save the following speedtest screenshots so that I could forward your case to the engineers for further assistance?

On the deco app it maxes out at 952mb up and down.
"I confirmed on my modem that I'm actually getting about 2.5gb down."

Thank you very much and wait for your reply.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! Deco BE85_1.1.1 Supports WireGuard VPN,Channel Selection and Matter Deco BE65_V2_1.1.0 Supports WireGuard VPN, Channel Selection and More ▶Deco APP 3.8.102/3.8.112-Ready for A New Deco Onboarding Experience! Try to leave a Message if urgent help is required.

Acshaw80

LV1

2024-01-11 01:12:08

Posts: 2

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2024-01-09

Re:Not getting max up/down speeds from my router

2024-01-11 01:12:08

@David-TP

Hi David

Thanks for your reply. I am using the cat6 cable supplied with the Deco BE85 router so this should not be the problem.

I tried plugging it into the 2.5 port, but I still get the same results. Below, please find the screenshots you were asking for. Thanks for your help.

9d66955ad47c44488e1b90155ee00162