VOIP failure with Ooma phone
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
My new router is actually a BE9300, which also identifies itself as an Archer BE550. I have been unable to get my Ooma Telo device to fully work with the router. It is able to make and receive calls, but no audio is heard by either side. I tried putting the device's IP into the DMZ and it didn't help. I also tried turning off the SIP ALG checkbox on the security/ALG page to no avail. My Ooma Telo device is working fine when connected to another router, allowing phone calls to work perfectly.
Is there some way to get the BE550 to stop interfering with the VOIP audio? I imagine that the router is filtering the VOIP packets and the SIP ALG switch isn't properly turning this filtering off.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Is the ooma connected via wifi or ethernet?
If ethernet, try a different cable and a different port on the router. Be sure to power cycle between changes. Also be sure you are using the power adapter that came with the router and not the one from the old router.
- Copy Link
- Report Inappropriate Content
@ArcherC8 It's connected via Ethernet. The same ethernet setup that works great connected to literally any other router. The new router is working fine for other things. It just interferes with VOIP.
- Copy Link
- Report Inappropriate Content
are you using QoS as that may be the issue.
you can also connect the ooma between the modem and router.
- Copy Link
- Report Inappropriate Content
@ArcherC8 I don't use QoS. I can't put the Ooma anywhere but behind the router, because my router is the thing getting the IP from my ISP. I could put another router in front of the tp-link, but I'd rather the tp-link do its job correctly.
This is a bug report to the tp-link folks for something that they need to fix. Is there a better way to let them know that this is broken?
- Copy Link
- Report Inappropriate Content
The ooma can be installed between the modem and router. No change to router. Router still does the ip. See the alternative network settings in the install guide.
google " ooma telo setup between modem and router" for the pdf guide.
I used that before my internet speed and service improved.
- Copy Link
- Report Inappropriate Content
@ArcherC8 Thank you for hammering that info home with me. I didn't realize that I could chain the router through the Ooma Telo. The Ooma does indeed work this way, as it then gets the public IP from the ISP and gives a 172.* (local network) IP address to the tp-link. This would presumably put a crimp into any advanced router setups where someone wants to manually configure an open port on the public IP address (since the router isn't handling the public IP anymore), but perhaps UPnP will auto-forward through the extra NAT device.
- Copy Link
- Report Inappropriate Content
@WayneD42 I connected the Ooma Telo between Xfiniti Modem and TP Link Router, but no signal to the router at all, and the Ooma Telo doesn't work too.
- Copy Link
- Report Inappropriate Content
Does the router work okay without the omma in between?
Does the ooma work when attached to the router?
Have you tested the cables?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 927
Replies: 8
Voters 0
No one has voted for it yet.