This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Whenever I try to perform network optimization I get the msg "Something went wrong. Try again later". This has been occuring for a while now. If there something I can try to resolove this problem? My system is running in Access Point mode. Thanks
I actually have not seen this behavior before, I would first try changing your DNS server to make sure that all necessary data is able to make it to the TP-Link servers.
When was the last time that your Deco Network was rebooted, and are all of your Deco Nodes still connected to the network?
@Riley_S Once I get home I'll verify my DNS. Also I rebooted this past weekend after installing the latest firmware update. Thanks
I get the same message each time I run the optimization scan. I run it a second time and the app indicates everything is "perfect "
Deco X95
This did not occur for the first month of my setup. One of my pair of units had an Ethernet port fail. The unit was sent back for replacement and this "something went wrong" message started while I was using just one unit. Second unit is back online and the message continues to pop up each time I initiate a scan.
Hope this additional information helps someone to figure out what is going on.
Helpful: 0
Views: 539
Replies: 3
No one has voted for it yet.
We use cookies and browser activity to improve your experience, personalize content and ads, and analyze how our sites are used. For more details, please read our Privacy Policy.
