Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > Deco X50 and Verizon Fios

< Deco

Deco X50 and Verizon Fios

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco X50 and Verizon Fios

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

LaRosaBob

2022-12-31 17:13:05

Posts: 3

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-12-30

Deco X50 and Verizon Fios

2022-12-31 17:13:05

Model: Deco X55

Hardware Version:

Firmware Version: 1.1.0 Build 20221102 Rel. 66085

I'm having difficult setting up my Deco X55 with Verizon FiOS. I have the G1100 Gateway router but internet only. I went into the G110 settings and released the DCHP Lease, turned off the G1100, disconnected the ethernet cable and plugged it into the X55. Everything was fine for a couple hours, then it lost internet. Everything is fine on the ONT.

Can I use the X55 as the main router or do I need to put the G1100 into bridge mode? (but that defeats the purpose?).

Thanks

2 Reply

David-TP

2023-01-03 07:19:23

Posts: 12476

Helpful: 1725

Solutions: 1200

Stories: 9

Registered: 2020-04-14

Re:Deco X50 and Verizon Fios

2023-01-03 07:19:23

@LaRosaBob

Hi, welcome to the community.

Will restarting the main Deco X55 be able to temporarily restore the internet connection?

If possible, it is suggested to clone the MAC address of the old G1100 on the Deco:

How to Configure MAC Clone on Deco if Deco fails to connect to the internet

Wait for your reply.

Best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! Deco BE85_1.1.1 Supports WireGuard VPN,Channel Selection and Matter Deco BE65_V2_1.1.0 Supports WireGuard VPN, Channel Selection and More ▶Deco APP 3.8.102/3.8.112-Ready for A New Deco Onboarding Experience! Try to leave a Message if urgent help is required.

LaRosaBob

LV1

2023-01-03 18:24:44

Posts: 3

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-12-30

Re:Deco X50 and Verizon Fios

2023-01-03 18:24:44

Thanks for the advice. Originally, a hard reboot would restore the connection, but only for a few minutes. I went through the same steps, but kept the main Deco unplugged while I did the release on the G1100. Plugged in the Deco. So far so good. Fingers crossed.

Deco X50 and Verizon Fios

Deco X50 and Verizon Fios

Information

Voters 0

Tags