Blink sync module won't recognize Deco XE5300

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Blink sync module won't recognize Deco XE5300

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

smiley47

2022-12-04 20:26:30

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-12-04

Blink sync module won't recognize Deco XE5300

2022-12-04 20:26:30

Model: Deco XE5300

Hardware Version:

Firmware Version:

My Blink sync module won't recognize the XE5300. It flashes "Blink-5W4C" is not connected to the internet. I've reset and moved it closer to another Deco unit with no success. How can I change Deco settings to allow the Blink to connect and be functional again? TIA

1 Reply

David-TP

2022-12-05 09:15:23

Posts: 12487

Helpful: 1726

Solutions: 1201

Stories: 9

Registered: 2020-04-14

Re:Blink sync module won't recognize Deco XE5300

2022-12-05 09:15:23

@smiley47

Hi, there are some suggestions for your reference:

1. turn off fast roaming and beamforming on the Deco APP>More>Advanced.

2. temporarily turn off 5ghz and leave 2.4ghz only.

3. also change the network security mode to WPA/WPA2.

Best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! Deco BE85_1.1.1 Supports WireGuard VPN,Channel Selection and Matter Deco BE65_V2_1.1.0 Supports WireGuard VPN, Channel Selection and More ▶Deco APP 3.8.102/3.8.112-Ready for A New Deco Onboarding Experience! Try to leave a Message if urgent help is required.

Blink sync module won't recognize Deco XE5300

Blink sync module won't recognize Deco XE5300

Information

Voters 0

Tags