Red light is on but the reset button doesn’t work
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have the S4 model. One of them has the red light on but I can't reset it using the button at the bottom. I've tried unplugging it and trying again but it doesn't work. How do I reset it?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, welcome to the community.
" can't reset it using the button at the bottom", Did you mean when holding the reset button, there is no change to LED status?
Please refer to the suggestions here to see whether S4 could get into firmware recovery mode： Power off Deco and use the pin to press and hold the reset button until powering Deco back.
If it is successful, you would be able to see the LED changes：
| Model |
Hardware Version |
LED status |
LED status |
LED status |
manual reboot |
| Deco M4/E4/S4 |
V1/V2 |
solid green |
solid green |
solid green |
yes |
How to use firmware recovery if the Deco become brick
Best regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 406
Replies: 1
Voters 0
No one has voted for it yet.