Using existing coax throughout home with Deco AXE5300 Wi-Fi 6E Tri-Band
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I'm getting 3 pack of the TP-Link Deco AXE5300 Wi-Fi 6E Tri-Band. I have Coax throughout the house already. I will remove my cable company's existing router. Can I plug 2 to 3 of them via coax? if so, what state do I need to put the devices in? Thank you!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Unfortunately, the Deco System, and most mesh systems for that matter, require an Ethernet Connection to hardwire your nodes. Since you already have coax running throughout the house, you could look into either using Coax to Ethernet Adapters to bridge the connection or could look into other methods of receiving hardwired connections through your house such as Powerline, or new Ethernet Cabling
- Copy Link
- Report Inappropriate Content
@tagcabo You will need a pair of moca connectors. I have one deco xe5300 hooked up this way the other deco uses the 6g backhaul.
- Copy Link
- Report Inappropriate Content
Thanks for chiming in, Its nice to hear that Moca connections work well with our Deco Systems. How difficult is it to configure the moca adapters? Is there any change in the stability or latency of the network when using this setup?
I have thought about using these in my home, but was always skeptical.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2216
Replies: 5
Voters 0
No one has voted for it yet.