Home Network Community > Wi-Fi Routers > Automatic Switching WDS Configuration
< Wi-Fi Routers

Automatic Switching WDS Configuration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Automatic Switching WDS Configuration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Automatic Switching WDS Configuration
Automatic Switching WDS Configuration
2020-08-11 02:19:21
Model: Archer A7  
Hardware Version: V5
Firmware Version: 1.0.14

Hi all,

I have configured WDS using another A7 router by following this faq https://www.tp-link.com/us/support/faq/1555/. Currently I am using two separate SSID's - it is my understanding that I can have the same SSID, but I was wondering how the network would handle switching between devices depending on signal strength? If I am on my extended router, and I move closer to my main router, will I automatically switch to the main router if the signal on the main router is better, or does the switch only happen if the signal is extremely bad on the extended router?

Thank you for the help!

  0      
 
  0      
 
#1
Options
5 Reply
Re:Automatic Switching WDS Configuration
2020-08-11 11:59:09
Mostly depends on the device as it selects the band. I prefer separate SSID names as it helps to determine what is going on if an issue occurs and allows me to balance the loads. Sounds like you want it to work like a Mesh system which switches bands more seamlessly.
  2  
  2  
#2
Options
Re:Automatic Switching WDS Configuration
2020-08-11 12:57:43

@ArcherC8 Yep I was considering setting up a mesh system for my next house, this setup is currently for a friend. I didn't know if there was a way to configure this with the default settings, or if I could install some open source firmware to help me accomplish this.

  0  
  0  
#3
Options
Re:Automatic Switching WDS Configuration
2020-08-11 15:00:05
The A7 should allow you to set up OneMesh. See the specs at https://www.tp-link.com/us/home-networking/wifi-router/archer-a7/#specifications and https://www.tp-link.com/us/onemesh/compatibility/.
  0  
  0  
#4
Options
Re:Automatic Switching WDS Configuration
2020-08-11 18:08:40

@ac130 Per this FAQ - https://www.tp-link.com/hu/support/faq/2690/ looks like 2 routers cannot work together for one mesh. Will do some research on whether enabling WDS vs  having other router as an Access Point has better service

  0  
  0  
#5
Options
Re:Automatic Switching WDS Configuration
2020-08-12 12:51:22
I have done some research on One Mesh and Mesh systems as I like to know in advance when it becomes time to replace my non-Mesh router an Archer C8 and RE220 extender. Right now I am leaning toward a Mesh system like the Deco M9. Although I have no experience with One Mesh, the Deco seems like a better way to go even if my current router was One Mesh capable.
  0  
  0  
#6
Options

Information

Helpful: 0

Views: 676

Replies: 5

Related Articles
Exported VPN config file not using DDNS
664 0
Configure second RE200
1310 0
How Can I tell if Finished with Configuration?
1119 0
configuration
145 0
How to configure the tp-link router | Now configure
1633 0
Cannot configure 6ghz band
3792 5
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.