AX6000 - Firmware Thread - 1.1.1 Build 20200714 rel.18254
AX6000 - Firmware Thread - 1.1.1 Build 20200714 rel.18254
I'm looking to update my AX6000 to the recently released firmware through online upgrade feature.
Did anyone try it out yet? I'm having a lot of troubles with 1.0.7.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I upgraded a few minutes ago. So far no problems. I'm looking for info on WPA3 support in this update.
- Copy Link
- Report Inappropriate Content
I've upgraded as well. I hope the 5GHz network will stop dropping off.
- Copy Link
- Report Inappropriate Content
I have issues with Link Aggregation feature. I have a Synology NAS that was running in the static mode. Currently I get about 5% of speed with Link Aggregation enabled.
- Copy Link
- Report Inappropriate Content
@Turowicz do you still suffer from same issiue with link aggregation?
- Copy Link
- Report Inappropriate Content
Hey after the update I've disabled the link aggregation and decided to go without it as I get much better speeds.
- Copy Link
- Report Inappropriate Content
So far I haven't had any issues with the new firmware.
I was having problems with my Nest Cameras working with this router using the 2.4Ghz band. I moved them all to one of the 5GHz bands and they are not having any problems now. They were dropping off and reconnecting randomly. I also would not see real time video in the website. I just thought it was due to the router, and glad to learn it too slow of a connection.
I also have IPV6 enabled and haven't had any issues with Comcast. Was going to enable the airtime fairness in the advanced settting to see if it will increase overall speed with new vs older devices.
I also have a Seagate 6TB drive connected to the USB 3 Storage and it is working ok. Sometimes it takes a bit to connect to it, but overall standard for a router.
- Copy Link
- Report Inappropriate Content
Yep, link aggregation broken after update, as my previous comments say.
- Copy Link
- Report Inappropriate Content
@Turowicz New firmware, same old same old 5GHZ dropping issue.
- Copy Link
- Report Inappropriate Content
5GHz has been stable for me in this update.
- Copy Link
- Report Inappropriate Content
@Turowicz Wish it had for me - been up and down all morning. Have reset the settings to Auto and will reboot (again) later.
The endless 5GHZ issues with this router has been a massive PITA>
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 4401
Replies: 12
Voters 0
No one has voted for it yet.