Router brick only power button and wps is only on after latest firmware update
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Every since I updated my router to the latest firmware my router has not been working probably by only the power button and the WPS lights are on. I don't understand the modem is connected to the router and all the lights should be on. Any ideas?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
You could also disconnect all the cables, only have the power supply connected, and factory default the router (hold reset for 15 seconds). All the LED lights should turn on then go off.
If the router continues to boot up and just shows the power and WPS, then I would contact support at that point.
- Copy Link
- Report Inappropriate Content
@Tony did that but still no response, tried 30-30-30 too..
Tony wrote
You could also disconnect all the cables, only have the power supply connected, and factory default the router (hold reset for 15 seconds). All the LED lights should turn on then go off.
If the router continues to boot up and just shows the power and WPS, then I would contact support at that point.
. Btw router is Archer C6
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2672
Replies: 4
Voters 0
No one has voted for it yet.