@Carl Thanks for the quick response.

Now, I'm encountering the following issue:

It was working all good, but now I started to get a "wrong password" on mobiles and a mac computer, on a windows computer is OK., I'm 200% the network password i'm entering is the right one. I have seen this is happening to other users. Any ideas what may be causing this?

Thanks

Carl wrote

@Oraugle 

 

In repeater mode it acutally work with your router to extend the wireless signal further than it would go normally.  What will happen is devices will connect to the AP that they are closest too or has the strongest signal.

Carl wrote

@Oraugle 

 

Apple devices typically like the higher channels in the specturm like channel 11.  try changing the rotuer's channel to 11 and see if that resolves the issue. 

@Carl Thanks for the reply., I just did the following:

Upgrade firmware to latest version on the tp-link site

Entered the configuration, I could not find where to change channels, but I did see it was already in channel 11 (picture below)

Reboot and it was OK., some minutes later, it went back to the same result: can connect to the network due to wrong password, it seems it works few minutes, but then it goes back to the same issue. It happens in 1 iphone, 2 androids and a mac

Any other thing to try?

Carl wrote

@Oraugle 

 

One thing to further test before we send this up to the Engineers is go under Wireless.  This is where you would change the channel manually.  Then disable (uncheck) WMM.  Save Reboot and test.  

@Carl Thanks for the reply., so here is what I've done:

• Disabled the WMM on the TPLink
• Still can't see where to change the channel., see the picture #1 below with current settings
• Reboot
• Tried with two computers now (pc/mac), they both connect to the furthest router even if it has a poor signal level, instead of connecting to tp-link repeater which is next to me, full signal. See a picture #2 below for reference (internet router MAC address ends in 83:9D, TPLink router MAC address ends in 21:5C)
• I moved away from the furthest router even more, and the computers can't connect to the repeater. They ask for the network password. Another example with different sw wifi analyzer in picture#3 below

I am assuming that, if I'm far away from the home router, devices will connect to the TP-link and, I would be to able doublecheck that with the MAC address of the repeater.

Many thanks in advance., looking forward to hearing from you. Don't hesitate in contacting me if you want me to troubleshoot more.

Picture#1: Setting options when trying to change the channel

Picture#2 Trying to connect to repeater: It always try to connect to 9D, even though the 5C (repeater) is closer. You can see also the bandwidth, channels, etc.

Picture#3 When moving further away,  (signal for home router 42% - the signal for repeater 82%) it should try to connect to the repeater, it tries but I get the wrong network password You can see additional info, maybe that gives you hints