M9 Deco connection issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

M9 Deco connection issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Renzo89

2020-03-12 16:03:41

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-03-12

M9 Deco connection issue

2020-03-12 16:03:41

Model: Deco M9 Plus

Hardware Version:

Firmware Version:

Hello everyone. I'm facing an issue where one of the slave deco's keeps losing connection with the main deco. Not so weird as the signal source is only one bar.

However, sometimes the slave deco gets its signal from the other slave deco and everything works much better. No connection drops and much better speed overall. This is what I want!

This is sadly temporary as the slave deco eventually seems to want to reconnect with the main deco.

Can I somehow force the slave deco to connect to the other slave deco?

1 Reply

Tony

2020-03-13 21:23:35

Posts: 6306

Helpful: 1491

Solutions: 165

Stories: 41

Registered: 2018-11-06

Re:M9 Deco connection issue

2020-03-13 21:23:35

@Renzo89

What you can look to do as a alternative is to possibly run a Ethernet cable from one slave to the other.

Or look at possibly doing a Ethernet backhaul, where you have a switch connecting to the main Deco and the other two wired to that switch.

M9 Deco connection issue

M9 Deco connection issue

Information

Voters 0

Tags