Pairing stops after a few minutes

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Pairing stops after a few minutes

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Pairing stops after a few minutes
Pairing stops after a few minutes
2018-10-17 02:45:11
Model :

Hardware Version :

Firmware Version :

ISP :

At first I had them on different circuits with one of them plugged into the router then I moved them so they would be in the same room and neither one was plugged into anything and the pairing stopped after a few minutes. When one of them was plugged into the router the other one had nothing plugged into it. I am going to try plugging something into the one and see If that makes a difference. Any suggestions. I have not update the firmware yet.
  0      
  0      
#1
Options
1 Reply
Re:Pairing stops after a few minutes
2018-10-17 14:53:15
When a PLC has nothing connected to its LAN port, it enters standby mode after a while. What exactly a "while" is depends on make and model.
  0  
  0  
#2
Options