C2300 Router drops internet speed to 350 Megabits up and down through centurylink Fiber, goes back to gigabit on reboot
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hardware Version :
Firmware Version :
ISP :
Hey there, I have a fresh C2300 that I'm using Centurylink Gigabit internet with. When freshly booted, I get speeds of 950 down and 950 down, all day long. However about 24-48 hours later it will drop to 350/350 without any warning whatsoever. Here's my config:
Ethernet from wall -
PPPoe
MTU 1492
Detect Online interval 10
All other lan settings auto
IPTV:
IGMP proxy enabled
IGMP version 2
Internet VLAN 201, 802.1q tag enabled.
What do I do?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@winternacht Do you still have this issue?
I have the same behaviour with my C2300 and I have it installed behind the Home Gateway from my ISP.
Although the C2300 memory usage shows around 50% and idle CPU usage below 5% only a power off /power on cycle will restore the speed to near gigabit download.
My ISP offers only 40 Mbps upload speed, so I never notice any speed reduction there.
Some info on the config:
The internet side is configured with static IP address and standard MTU of 1500 and with standard MAC address of the router.
The UPNP settings make no difference on or off.
The QOS settings are at default value and I have set no device priority
I have only 6 IP address reservations in DHCPNo Printserver or USB sharing functionality activated.
No IPTV configured
No port aggregation (no trunking)
No WiFi active (with button on router)
No static routing added
No virtual servers defined
No port triggering
No DMZ
No parental control
Antivurus and firewall setting are on (default)
No MAC address restrictions, Access control is off
IPv6 is disabled
No VPN configured
Time synchronized with pool.ntp.org
The router is at latest firmware "2.0.3 Build 20180810 Rel. 62903" for HW version "Archer C2300 v1.0"
In essence this router should have almost all of its capacity dedicated to pure routing my home network over NAT to the ISP.
- Copy Link
- Report Inappropriate Content
I have the same problem, my C2300 can run at 550 Megabits download 100mbs upload on reboot for about 2-3 minutes then goes down to 110 megabits download and 40 mbs upload afterwards. Any suggestions?
The modem/router that came with digital home runs at full speed 550 Megabits i'm getting to the point of binning the C2300, but it should work.
ISP - Digital home
I have the C2300
Hardware version V1
latest firmware.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 1646
Replies: 5
Voters 1
