No IPV6 on new AD7200
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
No IPV6 on new AD7200
Model :
Hardware Version :
Firmware Version :
ISP :
Despite the fact that I've followed all the instructions to enable and configure IPV6, every time I check with test-ipv6.com it keeps saying NO connectivity. On the status page it shows an IPV6 address issued by my ISP (router is set to Dynamic IP SLAAC DHCPv6). This is not an ISP issue because a few days ago I had an Asus AC3200 router that died on me, and on that one IPV6 worked perfectly. Same cable modem, same ISP, different router. What's going on here?
Hardware Version :
Firmware Version :
ISP :
Despite the fact that I've followed all the instructions to enable and configure IPV6, every time I check with test-ipv6.com it keeps saying NO connectivity. On the status page it shows an IPV6 address issued by my ISP (router is set to Dynamic IP SLAAC DHCPv6). This is not an ISP issue because a few days ago I had an Asus AC3200 router that died on me, and on that one IPV6 worked perfectly. Same cable modem, same ISP, different router. What's going on here?
Re:No IPV6 on new AD7200
Here is a screenshot of ipv6 section, with google dns selected it was the same with the Isp selected dns.
I dont have a clue why its not working.
My old router worked fine and not 6to4 tunnel as you can see DHCPv6 is selected in advanced
.the upper internet connection type is Dynamic Ip
Any help here?
is
