Radar detected on channels 36 and 48
I've am struggling with DFS. I get radar detected and it after a while it will change the channels to a non-DFS channel which is completely congested and unusable and I have to manually change this back every time.
I was looking into the logs and noticed that radar detection is also active on the lower channels. I'm not sure if any action follows out of this but I did find it peculiar.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
This is the design. Once the AP detects radar on the DFS channel, it switches to a non-DFS channel. You can only reboot it or wait 30 minutes before manually changing the channel.The radar detected on channels 36 and 48 may be due to your bandwidth settings of 160Mhz. If the radar is detected on channel 52-64 (DFS channel), the radar on the main channels 36 or 48 that you designated will be displayed in the log.
- Copy Link
- Report Inappropriate Content
This is the design. Once the AP detects radar on the DFS channel, it switches to a non-DFS channel. You can only reboot it or wait 30 minutes before manually changing the channel.The radar detected on channels 36 and 48 may be due to your bandwidth settings of 160Mhz. If the radar is detected on channel 52-64 (DFS channel), the radar on the main channels 36 or 48 that you designated will be displayed in the log.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 323
Replies: 1
Voters 0
No one has voted for it yet.