Built-in RADIUS Server authentication failed
Built-in RADIUS Server authentication failed
Hi everyone ,
I am using 802.1x port based authentication with Omada Built-in RADIUS server.
After enable tunnel reply in server setting the RADIUS client authentication failed.I also Enable VLAN assignment in setting.What should I do ?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
have switches access to radius server ip port? is switch on same vlan as the controller if not you have to do some firewaling..
- Copy Link
- Report Inappropriate Content
Yes, Switch can access the RADIUS Server IP.When I disabled tunnel reply in server settings RADIUS client connected with the IP address 192.168.0.xxx.I don't want to use like this.I want to use RADIUS server with VLAN assignment so I enable tunnel reply in server settings again the RADIUS client authentication failed.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@MR.S Yes , It work on WIFI, wireless client can access the internet with RADIUS user account also VLAN work properly . I want to test to you enable "tunnel reply" in server settings and then select Port Based authentication type and assign one port for wire client after that client PC plug into this port and login with RADIUS username and password.
MR.S wrote
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
I do a test and it work on Sg2008 Switch, I was redirected to vlan
the biggest problem with this radius server is that if you create a user in one site, the same user can log on to all sites.
if you have a controller with many customers, this becomes a security problem.
- Copy Link
- Report Inappropriate Content
@MR.S I have tested on TL-SG2210P and also TL-SG2428P .
- Copy Link
- Report Inappropriate Content
@MR.S I will show you at tomorrow more detail my configuration with screen capture .Thank for your kindly reply and help.
- Copy Link
- Report Inappropriate Content
Here my configuration , The first step i enable tunnel reply in server settings
The second step I selected on Port 11 as radius client as shown in figure
I create radius user with VLAN 10 and connect this port to PC .The RADIUS authentication is failed .
also the switch become HEARTBEAT MISSED.Sorry my bad in English.
- Copy Link
- Report Inappropriate Content
why heartbeat missing? I don't know.
same config as I do,
but you have to go to switch port and go to profile override and select auto to get it to work
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 3059
Replies: 13
Voters 0
No one has voted for it yet.