How to configure block of 5 static IPs on ER605

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to configure block of 5 static IPs on ER605

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to configure block of 5 static IPs on ER605
How to configure block of 5 static IPs on ER605
2023-01-31 00:39:31
Model: ER605 (TL-R605)  
Hardware Version: V2
Firmware Version: 2.0.1 Build 20220223 Rel.68551

I currently have an AT&T BGW-320 I am using in IP passthrough mode to my ER605.  I am wondering if I can configure this to use a block of 5 static IPs from AT&T.  I really need to use more IP+ports combinitions for Upnp. I am not using any omada controller.  I have a mesh wifi ap behind the er605 router also.

 

I would also like to use vlans to seperate my private stuff from public.  Is this possible and can you point me to instructions on how it is done.  

 

By my research I tihink I need to configure something in my BGW-320 and use one-to-one NAT in ER605.  Also, WAN need to configured as static. under Network->WAN. Is there more than that 

  0      
  0      
#1
Options
4 Reply
Re:How to configure block of 5 static IPs on ER605
2023-01-31 13:59:19

  @PackersOwner 

 

One-to-one NAT guide

Multi-nets configuration guide

  0  
  0  
#2
Options
Re:How to configure block of 5 static IPs on ER605
2023-01-31 15:41:51

  @Somnus thanks.  Can this all be done from the ER605 or do I need Omada controller?  I would prefer to not use Omanda controller unless someone can tell me why I need this.   My mesh APs sare DECO but I don't think Omada can control them

  0  
  0  
#3
Options
Re:How to configure block of 5 static IPs on ER605
2023-02-01 06:43:10

  @PackersOwner 

Yep the guide is for Standalone mode. Actually Controller mode even does not support one-to-one NAT.. I'm not using this function in personal, but I did see many other users send feedback in this community.

  0  
  0  
#4
Options
Re:How to configure block of 5 static IPs on ER605
2023-04-13 22:21:08

  @PackersOwner From the looks of this I can't get the router to do 1 to many NAT .  For example if I want all 10.0.1.x range to be on 123.456.78.90,  then I want 10.0.2.x to be on 123.456.78.91.   It can't do that correct?

  1  
  1  
#5
Options