Home

Forums

Stories

Knowledge Base

Business Community > Controllers > 2FA setup on OC200 with v5.0.29 firmware

< Controllers

2FA setup on OC200 with v5.0.29 firmware

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2FA setup on OC200 with v5.0.29 firmware

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

kasa_user

2022-01-08 23:01:23 - last edited 2022-01-13 08:52:08

Posts: 19

Helpful: 3

Solutions: 0

Stories: 0

Registered: 2019-12-21

2FA setup on OC200 with v5.0.29 firmware

2022-01-08 23:01:23 - last edited 2022-01-13 08:52:08

Model: OC200

Hardware Version: V1

Firmware Version: 1.14.2 Build 20211215 Rel. 61111

Where is the setting on the OC200 to set up two-factor authentication (2FA) once upgraded to the 5.0.29/1.14.2 firmware? I can't seem to find it - thanks.

1 Accepted Solution

Fae

2022-01-09 07:01:04 - last edited 2022-01-13 08:52:08

Posts: 3602

Helpful: 1358

Solutions: 474

Stories: 0

Registered: 2020-06-30

Re:2FA setup on OC200 with v5.0.29 firmware-Solution

2022-01-09 07:01:04 - last edited 2022-01-13 08:52:08

Dear @kasa_user,

kasa_user wrote

Where is the setting on the OC200 to set up two-factor authentication (2FA) once upgraded to the 5.0.29/1.14.2 firmware? I can't seem to find it - thanks.

After you login the Omada Cloud with your TP-Link ID, navigate to Settings in the bottom left corner, you will see Security menu to enable 2FA as picture below.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*

Recommended Solution

1 Reply

Fae

2022-01-09 07:01:04 - last edited 2022-01-13 08:52:08

Posts: 3602

Helpful: 1358

Solutions: 474

Stories: 0

Registered: 2020-06-30

Re:2FA setup on OC200 with v5.0.29 firmware-Solution

2022-01-09 07:01:04 - last edited 2022-01-13 08:52:08

Dear @kasa_user,

kasa_user wrote

Where is the setting on the OC200 to set up two-factor authentication (2FA) once upgraded to the 5.0.29/1.14.2 firmware? I can't seem to find it - thanks.

After you login the Omada Cloud with your TP-Link ID, navigate to Settings in the bottom left corner, you will see Security menu to enable 2FA as picture below.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*

2FA setup on OC200 with v5.0.29 firmware

2FA setup on OC200 with v5.0.29 firmware

Information

Voters 0

Tags