OC200 - Static IP Address

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

OC200 - Static IP Address

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
OC200 - Static IP Address
OC200 - Static IP Address
2020-11-28 08:48:03 - last edited 2020-12-01 06:24:54
Model: OC200  
Hardware Version:
Firmware Version:

I am about to build a small network with an OC200 and 4 EAP225 AP (3 ceiling and 1 outdoor).

 

It's only a domestic install, however rather than use DHCP in my network for fixed devices I prefer to use Static IP addresses.

 

Is it possible to set a static IP address for the OC200?

 

From the manual for the EAP225 it seems possible for them.

 

I'd prefer static over DHCP either with or without reservations.

 

Any thoughts?

 

Thanks

  0      
  0      
#1
Options
1 Accepted Solution
Re:OC200 - Static IP Address-Solution
2020-11-30 10:06:24 - last edited 2020-12-01 06:24:54

@willmoac 

 

Sure, you can set the static ip address under Setting, Controller, General Settings as below:

 

 

Regards

Recommended Solution
  5  
  5  
#2
Options
2 Reply
Re:OC200 - Static IP Address-Solution
2020-11-30 10:06:24 - last edited 2020-12-01 06:24:54

@willmoac 

 

Sure, you can set the static ip address under Setting, Controller, General Settings as below:

 

 

Regards

Recommended Solution
  5  
  5  
#2
Options
Re:OC200 - Static IP Address
2020-11-30 12:29:24
Great thanks!
  0  
  0  
#3
Options