GRE/IPSEC tunnel on TP-Link VPN router
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi there,
I found out all TP-Link router/modem supports LAN to LAN IPSEC VPN tunnel. Is it possible to have a tunnel interface which can be used for GRE/IPSEC tunnel? Any future plan to support this feature?
Thanks.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
bambinotenchie wrote
Hi there,
I found out all TP-Link router/modem supports LAN to LAN IPSEC VPN tunnel. Is it possible to have a tunnel interface which can be used for GRE/IPSEC tunnel? Any future plan to support this feature?
Thanks.
What GRE/IPSEC tunnel you mean? If you mea L2TP over IPSEC VPN, TP-LINK SMB Router supports it.
- Copy Link
- Report Inappropriate Content
Hi.
Does it support tunnel with an IP address on both side. I knew some of TP-Link SMB router supports L2TP but not all.
Thanks.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, Thanks but I think I need to explain abit detail. What I meant with Tunnel with IP address is like as shown below (using Cisco as an example):
!
interface Tunnel1009
description RemoteOffice No: 92225166 LocID : 1009 LAN: 10.41.1.254
ip address 172.16.90.37 255.255.255.252
ip mtu 1400
ip tcp adjust-mss 1100
ip policy route-map DMZ-LAN
tunnel source 100.100.100.1
tunnel destination 211.211.211.1
tunnel path-mtu-discovery tunnel protection ipsec profile MTPROF
ip virtual-reassembly
end
!
This tunnel is similar to other tunnel setting. Thanks.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 5524
Replies: 4
Voters 0
No one has voted for it yet.