SYS LED blinking on TP-Link 2600G-52ts managed switch

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

SYS LED blinking on TP-Link 2600G-52ts managed switch

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
SYS LED blinking on TP-Link 2600G-52ts managed switch
SYS LED blinking on TP-Link 2600G-52ts managed switch
2019-06-04 03:25:47 - last edited 2019-06-04 04:34:46
Hardware Version: V3
Firmware Version:

Hi after opening and connecting to the web gui of the managed switch I've tried to configure some setting but after turn off the IPV6 enable settings..then I can't connect to the switch... I can't even ping it... I tried rebooting the switch then noticed that the SYS LED starts blinking.. That means the switch is improperly working right? Any help or tips?

 

Edit: so finally after rebooting a lot , we managed to open the GUI but the SYS LED is still blinking.. we tried to restore to factory default but its still blinking..

  0      
  0      
#1
Options
2 Reply
Re:SYS LED blinking on TP-Link 2600G-52ts managed switch
2019-06-04 10:04:16

Hi mariem56

 

The normal status of SYS LED is blinking. The POW LED light all the time. If you can manage the switch, then it works normally.

  2  
  2  
#2
Options
Re:Re:SYS LED blinking on TP-Link 2600G-52ts managed switch
2019-06-06 01:23:17

Thank you.

  0  
  0  
#3
Options