Home

Forums

Stories

Knowledge Base

Business Community > Controllers > Controller doesn't show ETH0 of EAP615

< Controllers

Controller doesn't show ETH0 of EAP615

Controller doesn't show ETH0 of EAP615

Controller doesn't show ETH0 of EAP615

2025-03-18 11:02:19 - last edited 2025-03-22 07:02:00

Posts: 46

Helpful: 8

Solutions: 0

Stories: 0

Registered: 2024-10-01

Controller doesn't show ETH0 of EAP615

2025-03-18 11:02:19 - last edited 2025-03-22 07:02:00

Tags: #Controller

Model: Omada Software Controller (Windows)

Hardware Version:

Firmware Version: 5.15.20.13

Hi all,

based od suggestion from Clive_A, I open the issue here:

the EAP615 access points cannot identify their own ports using LLDP - map says, I'm connected to port 3 of switch - but via which port? physically they're connected via ETH0....

and just now I've noted, that in controller I can see/configure only three ETH ports (1-3) - ETH0 is missing........

EAPs are connected to the network via PoE ports of SG2008P

firmware versions:

Controller: 5.15.20.13 (Windows based)
EAP615 v1.0: 1.5.0 Build 20240830 Rel. 63168
SG2008P v3.20: 3.20.5 Build 20250117 Rel.60471
ER605 v2.0: 2.2.6 Build 20240718 Rel.82712

/BR ZoloNN ------------------------------------------------------------------------------------ Omada 2x ER605(UN) v2.0 + SG200P(UN) V3.20 + SG2218 V1.20 + 2x SG2008 V4.20 + 3x EAP615-Wall(EU) V1.0

0

0

#1

1 Accepted Solution

2025-03-19 07:11:10 - last edited 2025-03-22 07:02:00

Posts: 2132

Helpful: 233

Solutions: 830

Stories: 0

Registered: 2024-06-22

Re:Controller doesn't show ETH0 of EAP615-Solution

2025-03-19 07:11:10 - last edited 2025-03-22 07:02:00

Did you try reboot the EAP?

If possible, you may try to reboot the devices in the following order:

controller>router>switch>EAP615-wall

Or you can try forget the EAP615-wall and re-adopt it. see if it works.

Wish you a happy life and smooth network usage! >Get the Latest Omada SDN Controller Releases Here< >Experience the Latest Omada EAP Firmware<

Recommended Solution

0

0

#2

1 Reply

2025-03-19 07:11:10 - last edited 2025-03-22 07:02:00

Posts: 2132

Helpful: 233

Solutions: 830

Stories: 0

Registered: 2024-06-22

Re:Controller doesn't show ETH0 of EAP615-Solution

2025-03-19 07:11:10 - last edited 2025-03-22 07:02:00

Did you try reboot the EAP?

If possible, you may try to reboot the devices in the following order:

controller>router>switch>EAP615-wall

Or you can try forget the EAP615-wall and re-adopt it. see if it works.

Wish you a happy life and smooth network usage! >Get the Latest Omada SDN Controller Releases Here< >Experience the Latest Omada EAP Firmware<

Recommended Solution

0

0

#2