Hi! I am having an ER706W, but guess this is still a wifi and not a router topic: I am trying to set up another SSID to use two VLAN, but my new SSID is not showing up...

My goal is to have separete VLANs (us / our tenants). The first (default) Wifi has as well wired devices, the new network currently only wifi, but that might change.

Steps I did:

- Created new SSID in controller's WLAN settings, with VLAN ID 2. Of course SSID Broadcast is enabled, SSID is "test", 2.4 GHz and 5 GHz enabled. Set to EAP (maybe I should have enabled "Gateway" as well?). No wired devices are in this group, should I still set up a LAN, and if yes, "Interface" or "VLAN"? The later does not allow a separate IP range, which in the end I don't really care as long as the devices don't see each other... (which might mean I need Interface?)

- The first/default SSID works, has no VLAN ID in the wifi settings. This has a LAN setup, "Interface" type, and VLAN ID1 (which I cannot enter at the WLAN settings, but I guess I should?) This default network has also devices wired to the router.

- Both above SSIDs are in the same group "default"

Looking at the ER706W in Config -> WLANs, only my default WLAN shows up and is enabled, the new one "test" does not show.

Also, scanning for SSIDs does not show this new one. What am I missing?