I am angry why static IP addresses cannot be configured on ER605 and SG2008P?
After many weeks of browsing models and their specifications, I picked one that was supposed to meet my expectations. Unfortunately, it doesn’t, and I’m disappointed – a lot of money went to waste. Either I was given bad advice, or I misunderstood something.
I need to configure VLANs so that devices on selected ports can communicate with each other, even if they are in different VLANs. I’d also like to assign a specific client a static IP address from a designated VLAN pool. Unfortunately, I can’t do this because I don’t have options like “Network Security,” “ACL,” or “Bind IP.” Why are these features unavailable to me?
Additionally, I have a device that requires not only a static IP but also port forwarding for a specific port to that IP. I can’t find this option in my configuration, even though it’s available in the demo.
Hardware specifications:
- ER605 v2 – updated to version 2.2.6
- SG2008P v3.2 – updated to version 3.20.1
- OC200 – updated to version 5.14.32
In the Omada Controller, I have version Essential v1.1.1, which seems odd because the demo shows version 5.9 in the same place. What’s going on here?