Not able to connect BETWEEN 2 cpe ANTANA

Not able to connect BETWEEN 2 cpe ANTANA

Not able to connect BETWEEN 2 cpe ANTANA
Not able to connect BETWEEN 2 cpe ANTANA
Yesterday - last edited 10 hours ago
Model: CPE510   CPE610  
Hardware Version: V7
Firmware Version:

configured everything properly in my PC within the Room and Placed the Astana in my 2 nd Floor roof and my Client is nearly 1.5km Distance after that I installed the Client in 20 feet Height and tried to connect the internet But the signal is Not showing in the Client it self 

 

 

 

Kindly help me to resolve the issue 

 

 

 

 

Notew: is really need to see the antana from my Client side..? by Human Eyes, also 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Not able to connect BETWEEN 2 cpe ANTANA-Solution
10 hours ago - last edited 10 hours ago

Hi  @wolf98 

 

You may first bring the client CPE close to the access point EAP, and refer to the following guide to link the two units:

How can I set up the AP + Client topology successfully?

 

After you successfully configured the client CPE, you can install it on the second point.

 

For the distance, you may configure the distance setting as 1.6 km.

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Not able to connect BETWEEN 2 cpe ANTANA-Solution
10 hours ago - last edited 10 hours ago

Hi  @wolf98 

 

You may first bring the client CPE close to the access point EAP, and refer to the following guide to link the two units:

How can I set up the AP + Client topology successfully?

 

After you successfully configured the client CPE, you can install it on the second point.

 

For the distance, you may configure the distance setting as 1.6 km.

Recommended Solution
  0  
  0  
#2
Options